![]() The same methodology use the Altium PCB Collaboration, using the SVN. After each complete, the whole PCB board was marge for each PCB. Each “PCB draftsman” are the own PCB area, and route the connection. PCB collaboration is to one of the methodology to speed up the time to complete the PCB. But the new one is the PCB board, rare could be stick together the old PCB, board, mostly the PCB have to be made for scratch. It is rare in electronic to start the schematic for scratch, mainly there are several sheet used for old project, like power supply, DC-DC converters, the processor- memory unit, front-end amplifiers, ADC. It work that the PCB file in Board Station are ASCII files, and the merging is easy, as could be in KiCad. On page 6-th there are some description about Team Work. Is Team Collaboration, see the “Team PCB”, for old Board Station from the Mentor Graphics There is another possibility to use the merging two or more boards. I am leary of doing any DCR checks as I can do all of that as individual designs. These designs share a lot of net names as they are very similar mainly differing in layouts. Any clue what is going on?ĮDIT: I got something to work but not following the directionsĢ.) opened a complete PCB layout using pdbnew from the project.ģ.) “ save as” from pcbnew as XXXX_prototype.Ĥ.) I then used windows explorer to open the XXX_prototype.kicad_pcb file pointing to pcbnew.ĥ.) Now with the first PCB in the layout I started using “Append board” to add two others. I basically get the same error on several layouts I have tried. When I try to open any one of a few layouts I get this error message. Platform: Windows 7 (build 7601, Service Pack 1), 64-bit edition, 64 bit, Little endian, wxMSW Later I will panelize a single design with say a 2x3 array (Qty 6) to fit into a toaster over.įor now, to give these instructions a try, I found the pcbnew application and started it as Administrator (version below)īuild: wxWidgets 2.9.4 (wchar_t,compiler with C++ ABI 1002,GCC 4.7.2,wx containers,compatible with 2.8) I’m trying to combine 3 PCB designs for a prototype run to get a lower cost on the first version of each of three designs and get a single stencil to assemble these first prototypes. I like this answer but having problems with doing it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |